J
jakubklapka
Hello, recently, my MIL indicator lit up and once I got my simple OBD reader out, I was presented with this:
To my surprise, I have not found anybody dealing with this, especially the combination. Since both came on together, I doubt that either the valve or pump failed at the same time. So maybe I'm dealing with some cable damage? Or does anybody have an idea what this could be? What troubleshooting steps would you recommend? I've drove multiple times with it without noticing anything unusual.
T6.1, MY2019, 2.0 110kW, 4MOT, DSG, CXFA.
Thank you for any ideas!
01. Engine control unit01. Engine control unit
DTCs: 2
----------------------------
27228 [0x006A5C]
P165F00: Oil pressure regulation valve, Short circuit to ground
Status: Test failed, Test failed (current drive cycle), Pending, Confirmed, Test failed since last DTC clear, Warning indicator requested
----------------------------
27173 [0x006A25]
P16BF00: Heater support pump, Short circuit to ground
Status bits: 1
Priority: 2
Frequency: 1
Unlearning index: 255
Odometer: 58151 km
Date, time: 2026.07.14 23:20:42
Engine RPM: 1160 rpm
Calculated engine load value: 46.67 %
Vehicle speed: 14 km/h
Engine coolant temperature: 90 ℃
Intake air temperature: 18 ℃
Barometric pressure: 96 kPa
Klemme 30 voltage: 13
Paramteric values: 20 96 28 44 84 24 C9 44 83 00 00 44 84 24 C9 44 8C 25 1C
Status: Test failed, Test failed (current drive cycle), Pending, Confirmed, Test failed since last DTC clear, Warning indicator requested
To my surprise, I have not found anybody dealing with this, especially the combination. Since both came on together, I doubt that either the valve or pump failed at the same time. So maybe I'm dealing with some cable damage? Or does anybody have an idea what this could be? What troubleshooting steps would you recommend? I've drove multiple times with it without noticing anything unusual.
T6.1, MY2019, 2.0 110kW, 4MOT, DSG, CXFA.
Thank you for any ideas!













