Interior Trim Above Sliding Door Blind (For Dashcam Cable Run)

Zathras

Zathras

VIP Member
Messages
41
Location
London
Vehicle
T6.1 Beach Tourer 150
California T6.1 (2021) Beach

Running a cable from front screen to rear screen, for the rear dashcam camera.

I've got to the rear of the B-Pillar, however struggling to get the cable into the trim above the opening door, specifically the end near the B-Pillar.

I'm trying to go via the top most part of that trim next to the bed base, rather than via the blind.

From just after the light (where my finger is in the photo) I can open a gap enough to get the cable in and fairly sure I could go the rest of the way at that point.

The wide section near the B-Pillar is just too tight though and I think I need to remove the entire trim section to feed the cable properly.

Looked extensively to see how you'd remove this, which I presume must be necessary if you were to replace a faulty blind, but come up blank.

Can anybody point me the right direction here or have any tips to share? Thanks.

View attachment IMG_5573.jpeg

View attachment IMG_5572.jpeg
 
Pop the lights out and use the void to run the cable?


Edit : search results "trim removal" :



Hope that helps
 
Last edited:
Did already see the second one and it didn't help, missed the first one and it has the magic answer really:
Yes i can confirm its glued on you need to slide a small screwdriver along and pull at the same time this then releases also i found another small bolt screw at the tailgate end you need to remove the rear trims to reveal it !
Drat. (presuming its the same on a T6.1)

So @Perfectos, your idea of popping the lights is next - thanks.

I had pulled the cable back out before the photo, but was using that void by pushing in from above where it meets the bed - just cannot do that for the wide section. So, will see if I can do it via the light opening with some coat hanger.
 
Last edited:
Did already see the second one and it didn't help, missed the first one and it has the magic answer really:

Drat. (presuming its the same on a T6.1)

So @Perfectos, your idea of popping the lights is next - thanks.

I had pulled the cable back out before the photo, but was using that void by pushing in from above where it meets the bed - just cannot do that for the wide section. So, will see if I can do it via the light opening with some coat hanger.

I popped lights and the aircon control unit and, most importantly, bought rods off amazon. It was actually hardest to get it behind the airplane locker in the end.
 
I popped lights and the aircon control unit and, most importantly, bought rods off amazon. It was actually hardest to get it behind the airplane locker in the end.
Good to know someone’s been successful this route before, thanks.

What kind of rods did you get off of Amazon?

Mines a T6 1 beach, so I don’t think I have an Aircon control to worry about or Airplane locker? I presume these are ocean bits I don’t have.
 
UPDATE: I managed to get the cable routed through to the rear.

I popped the lights for the above door bit, and took off rear vertical D-Pillar trim on that side.

Using a modified wire coat hanger, got it through both sections - was especially tricky on the section above the window as hanger only just reached and there were obstructions. So although I wished for rods, I did manage it.
 

Similar threads

Back
Top