Zathras
VIP Member
California T6.1 (2021) Beach
Running a cable from front screen to rear screen, for the rear dashcam camera.
I've got to the rear of the B-Pillar, however struggling to get the cable into the trim above the opening door, specifically the end near the B-Pillar.
I'm trying to go via the top most part of that trim next to the bed base, rather than via the blind.
From just after the light (where my finger is in the photo) I can open a gap enough to get the cable in and fairly sure I could go the rest of the way at that point.
The wide section near the B-Pillar is just too tight though and I think I need to remove the entire trim section to feed the cable properly.
Looked extensively to see how you'd remove this, which I presume must be necessary if you were to replace a faulty blind, but come up blank.
Can anybody point me the right direction here or have any tips to share? Thanks.
View attachment IMG_5573.jpeg
View attachment IMG_5572.jpeg
Running a cable from front screen to rear screen, for the rear dashcam camera.
I've got to the rear of the B-Pillar, however struggling to get the cable into the trim above the opening door, specifically the end near the B-Pillar.
I'm trying to go via the top most part of that trim next to the bed base, rather than via the blind.
From just after the light (where my finger is in the photo) I can open a gap enough to get the cable in and fairly sure I could go the rest of the way at that point.
The wide section near the B-Pillar is just too tight though and I think I need to remove the entire trim section to feed the cable properly.
Looked extensively to see how you'd remove this, which I presume must be necessary if you were to replace a faulty blind, but come up blank.
Can anybody point me the right direction here or have any tips to share? Thanks.
View attachment IMG_5573.jpeg
View attachment IMG_5572.jpeg













