Folding seats to make up the bed

B

Bongoloidfloyd

Messages
45
Location
Bongoland
Vehicle
Since new I have been having problems with the rear seats.

When making up the bed I pull them forward, push down the rears, the headrests live back to front anyway. Slide flattened seats back into position.

So far so good, however, the seat backs are a very snug fit, so much so that the plastic seatbelt surround has been ripped off once, the seat fabric will start to get scuffed soon as well.

I am positive that the seat backs will not go any more flat, I have tried and tried.

Can the overall seat height be adjusted somehow or does anyone else have a solution?

Cheers.
 
Before you “push down the rears” make sure the seat back is fully reclined using either of the two outer pull loops.
Then use the centre pull loop to flatten.


Sent from my iPhone using Tapatalk
 
Before you “push down the rears” make sure the seat back is fully reclined using either of the two outer pull loops.
Then use the centre pull loop to flatten.


Sent from my iPhone using Tapatalk
Thanks,

I am sure that has been tried but next time I shall try again before pulling the centre strap.
 
Still a very snug fit, the plastic surround for the seat belt is rubbing against the board and both are being marked plus the fabric is starting to pull.
 
As well as the back rest adjustment to slide the seat back under the board the headrest can be taken out by pressing the collar inwards between the headrest and seat and refitted the opposite way round. It will then slide under to make the bed up.
The seatbelts can be pushed down between the seats so they dont foul the fabric…this is applicable to the Multivan Cali (T7) so must be very similar to the preceding models
 
Since new I have been having problems with the rear seats.

When making up the bed I pull them forward, push down the rears, the headrests live back to front anyway. Slide flattened seats back into position.

So far so good, however, the seat backs are a very snug fit, so much so that the plastic seatbelt surround has been ripped off once, the seat fabric will start to get scuffed soon as well.

I am positive that the seat backs will not go any more flat, I have tried and tried.

Can the overall seat height be adjusted somehow or does anyone else have a solution?

Cheers.
Jeez! How hard are you pushing the seats back. As a side note we don’t carry the seat nearest the cooker/sink it gives us more room for other things.
 
It's a four part process - headrest backwards, pull seat forward, pull centre pull tag and pull side pull tag to fully flatten seats. Check out California Chris - think he shows this in an early video about the new T7 Cali. Good luck
 
Can you add a pic of the issue, we have also removed the seat nearest the sink. We have no probs sliding the seat back under the bed board (it is tight ) without marking anything.

att.JqavE9q9jKF8YZ9P_enG6QmyrdQH2vDrn4Z14sfOYiI.jpeg
 
That doesnt look like the standard mattress in the picture for the T7? Where is the plastic rubbing? Is it between the seat side and the main trim of the body? Or where the mattress board rubs on top of the seat side trim?
 
It's a four part process - headrest backwards, pull seat forward, pull centre pull tag and pull side pull tag to fully flatten seats. Check out California Chris - think he shows this in an early video about the new T7 Cali. Good luck
Looking at the back seats the RHS one slides back easily, the LHS fouls the board. I operated both exactly the same.
 
I note your location is 'Bongoland'. ... things can be a tight fit in Bongoland!
 
Last edited:
Back
Top