EcoFlow DELTA 3 Classic + 600W Alternator Charger installation in T6.1 coast

[Olivier&Lory]

Hi everyone,
I’m looking for some advice from anyone who has installed an EcoFlow DELTA 3 Classic together with the EcoFlow 600W Alternator Charger in a VW California T6.1.
I’m currently trying to decide where to install everything. I’m considering either:
behind the driver’s seat, or
in the rear luggage/boot area.
I’d like to keep the installation as clean and practical as possible, while keeping everything easily accessible.
Has anyone done a similar installation in a T6.1?
If so, I’d really appreciate any advice on the best location. And even better, if you have photos of your installation, I’d love to see them!

 

[Betsycalifornia]

Delta 3 plus, behind the drivers seat until parked up and then between the seats, EcoFlow 800 watt charger under the drivers seat, connected to the split charge relay under the passenger seat.

 

[Olivier&Lory]

Thanks for the advice! I’m going to install my EcoFlow Delta 3 Classic in the rear storage .


I have one question though: does anyone have any advice on how to route the cable from underneath the driver’s seat to the rear storage area, going through or underneath the kitchen furniture, without having to remove the floor?


I’ve already installed lino on the floor, so I’d really like to avoid taking it up again.


Ideally, I’d also like to route the cable without having it visible along the outside of the kitchen unit.


Has anyone done this on a T6.1 California Coast and found a clean way to do it?


Thanks in advance for any advice!

 

[Olivier&Lory]

I can't manage to route my cable to the battery. How do you do it?

 

[akprincehbd]

I want to know this also. But I think there is no gap or anything slot either at bottom or back of the kitchen furniture, how to feed the cable through?

 

[samhu]

Hi:newbie here,I assume your EcoFlow 600W Alternator Charger is the new one with a white wire to connect to car start up,Would like to know how and where to connect it? I'm planning to put a EcoFlow 1000W Alternator Charger on my T6.1
Thanks!
Sam

 

[Kayleigh]

Hi:newbie here,I assume your EcoFlow 600W Alternator Charger is the new one with a white wire to connect to car start up,Would like to know how and where to connect it? I'm planning to put a EcoFlow 1000W Alternator Charger on my T6.1
Thanks!
Sam

View attachment 153212

View attachment 153213

If that’s for the engine running signal, there is a small black wire on the input side of the split charger to detect this. Maybe you could hook up to that. Will let any more electrically minded people add to that.