Trolley jack saddle pad search

[nigpdreadingfc]

I'm looking for a suitable saddle pad to fit my Clarke Ctj3000C 3 tonne trolley jack.
The popular pads that have a groove to fit the pinch weld would be ok for the front jack points, but by the rear jack points there is a close "tab" on the suspension leg, which would foul on the saddle pad.
Has anyone been able to overcome this and what was used? I've had a look at an aluminium slotted puck here https://amzn.eu/d/06cfdT0v, but don't know if this would be suitable.
Any help would be much appreciated. Thanks in advance

 

[sidepod]

Unless you’re planning to remove a suspension arm, forget jacking on the body, place the jack under the suspension arm.
Doing this greatly reduces the amount of lift required to lift the tyres off the ground as you’re jacking on the sprung side of the chassis.