Noisy rattling cabin when driving

P

pips123

Messages
16
Location
Bracknell
Vehicle
T5 Beach 4Motion
When driving , the noise inside the van is all about rattles and chunks. . Some of the noise originates from a slightly loose table and we managed to cut that specific noise out by putting a towel between it and the drawer unit. Still, it does rattle a lot from other areas but we cannot ascertain its origins. Has anyone experienced similar problems ? Any ideas sector when those rattling noise might come from ? Thanks
 
When driving , the noise inside the van is all about rattles and chunks. . Some of the noise originates from a slightly loose table and we managed to cut that specific noise out by putting a towel between it and the drawer unit. Still, it does rattle a lot from other areas but we cannot ascertain its origins. Has anyone experienced similar problems ? Any ideas sector when those rattling noise might come from ? Thanks
According to your Avatar information you have a T5 Beach 4 Motion. This vehicle doesn't have such a table. So which vehicle do you actually have?
 
When driving , the noise inside the van is all about rattles and chunks. . Some of the noise originates from a slightly loose table and we managed to cut that specific noise out by putting a towel between it and the drawer unit. Still, it does rattle a lot from other areas but we cannot ascertain its origins. Has anyone experienced similar problems ? Any ideas sector when those rattling noise might come from ? Thanks
One we filled ours with camping clutter the rattles disappeared, one was the bed extension, a small amount of electrical insulation tape sorted that one.
 
I have a T6 California
That makes sense. It helps if you have the correct information on your Avatar.

Table- when sliding it back you have to push the bottom edge in, towards the kitchen, so that the table catch engages with the kitchen catch.

The awning can be a cause - wind it out 6" and then back in firmly but not with too much force.
 
That makes sense. It helps if you have the correct information on your Avatar.

Table- when sliding it back you have to push the bottom edge in, towards the kitchen, so that the table catch engages with the kitchen catch.

The awning can be a cause - wind it out 6" and then back in firmly but not with too much force.
Thank you!
 
Back
Top