2011 Cali pop top roof fault 1000

[marksea1205]

Hi, I have the 1000 fault on my 2011 Cali and the roof will not operate now at all. I have seen in other posts that the roof can be raised by connecting
a 12V supply directly to the hydraulic pump. Does anyone have any pictures of how to access the pump connections?

Also I know there are some specialist garages out there but I am in Glasgow so if anyone knows any decent garages in the Scotland central area that
also might be an option. Any recommendations?

Thanks

 

[WelshGas]

Hi, I have the 1000 fault on my 2011 Cali and the roof will not operate now at all. I have seen in other posts that the roof can be raised by connecting
a 12V supply directly to the hydraulic pump. Does anyone have any pictures of how to access the pump connections?

Also I know there are some specialist garages out there but I am in Glasgow so if anyone knows any decent garages in the Scotland central area that
also might be an option. Any recommendations?

Thanks

Remove Control Panel and on the rear, L hand side is a connector with 2 wires. SEE BLUE ARROW BELOW.
Connect these 2 wires to a 12v battery +tve and -tve . The +tve should have a 30 amp fuse in line.
Connected the motor will power up to either lower or raise roof. Just reverse the connections depending on what you want.

 

[Lambeth Cali]

Sometimes clearing the codes and turning the controller off and on might work if you’re very lucky!

 

[marksea1205]

Remove Control Panel and on the rear, L hand side is a connector with 2 wires. SEE BLUE ARROW BELOW.
Connect these 2 wires to a 12v battery +tve and -tve . The +tve should have a 30 amp fuse in line.
Connected the motor will power up to either lower or raise roof. Just reverse the connections depending on what you want.
View attachment 148757

Thank you. I think part of the picture is greyed out but I see where you mean. So just need to remove some of the insulation foam to access it eh? I will get a chance to have a look in a couple of weeks.

 

[marksea1205]

Sometimes clearing the codes and turning the controller off and on might work if you’re very lucky!

Hi, I had seen posts about this and maybe even yourself. I can't clear the code as when I press the button suggested to clear the alarm it just goes back to the previous display. I think I will need to try the powering down option first if anything, thank you