Connecting Up An EcoFlow Delta 3

[DoodleBugs123]

Morning all,

After a bit of advice here. I have a 100KW panel and Victron MPPT (From Roger), I am going to purchase the EcoFlow Delta 3 to have that sit between the front seats. The MPPT is located in the rear cupboard. Can anyone advise what is the easiest / best way to route the cabeling to the rear. I was thinking of running it behind the fridge and then either up where the leisure battery is or up in to the rear cupboard. If this is not straightforward, it may be a case of running along the floor under the carpet at the base of the cupboards.

Many thanks in advance.

Rich

 

[myvanrodney]

Im interested too ...

 

[DoodleBugs123]

From Roger… Poke the wire behind the battery, going right – it will come through behind or over the fridge “workings”. In the lower cupboard by the bench seat, remove the large round plastic cap and you can see inside – I use a plastic rod to get the wire through, but anything, even a stiff wire, will work, then you can run it behind the cutlery drawers and to the seat. Use a 2.5mm squ wirre, 2mm squ minimum, to prevent too much voltage drop.